Adam Pribyl (2014-11-22 01:28 +0300) wrote:
I have folloed the instruction in
http://www.gnu.org/software/guix/manual/guix.html#Emacs-Interface
to get the emacs interface for guix, but there is something missing
probably.
Installation of emacs and geiser was OK, I changed the path to guix.el
(there is no /usr/share/ in my guix installation, I had to find guix.el
in the /gnu/store), after that I can start emacs and "M-x guix-..." but
every action says "Cannot open load file: no such file or directory
geiser-mode".
If you mean you did (add-to-list 'load-path "/gnu/store/..."), then it's
definitely not right.
There should probably be also the geiser path in the emacs init file or
something?
I assume you use a Guix (or GNU or whatever it should be called)
system. I must admit I have not tried it yet, and all I know about
setting "guix.el" there I learnt from a chat with davexunit on #guix
today.
So I think the following should be added to your emacs config:
- Add dirs with "guix.el" and "geiser" to load-path (I'm absolutely
not sure about the correctness of the paths, so double check please):
(add-to-list 'load-path "/run/current-system/profile/share/emacs/site-lisp/")
(add-to-list 'load-path "~/.guix-profile/share/emacs/site-lisp")
- Initial setup of geiser:
(require 'geiser-install)
- Initial setup of guix:
(require 'guix-init)