Re: Check Host in MONIT

[Martin Pala]

you can use any of "succeeded", "passed" or "recovered" in the config file.

If monit crashed, can you provide output of "pstack <core>"? Which monit 
version it is?

Martin


On Apr 11, 2011, at 3:27 PM, Paul Sun wrote:

> Should I use "if succeeded" or "if passed"?
> 
> BTW, I noticed that the monit is core dumped before, anything can help
> to check?
> 
> - PS
> 
> -----Original Message-----
> From: address@hidden
> [mailto:address@hidden On
> Behalf Of Martin Pala
> Sent: Monday, 11 April, 2011 21:23
> To: This is the general mailing list for monit
> Subject: Re: Check Host in MONIT
> 
> Yes, this setup is possible - the recovery/succeeded action will be
> executed only on failure->success change however (if the service was up
> when monit started, no action is done). You can check logs to see
> whether the action was executed on service recovery.
> 
> Regards,
> Martin
> 
> On Apr 10, 2011, at 3:16 PM, Paul Sun wrote:
> 
>> Hi 
>> 
>> I would like to know whether monit support to action if the check host
>> is success? I tried below configuration, but doesn't seems work
>> 
>> - PS
>> 
>> check host SERVER1 with address 10.219.35.80
>>   if failed icmp type echo count 3 with timeout 3 seconds then alert
>>   if failed port 2054 then exec "/user/scripts/set_alarm.sh"
>>       else if succeeded then exec "/user/scripts/clear_alarm.sh"
>> 
>> --
>> To unsubscribe:
>> http://lists.nongnu.org/mailman/listinfo/monit-general
> 
> 
> --
> To unsubscribe:
> http://lists.nongnu.org/mailman/listinfo/monit-general
> 
> --
> To unsubscribe:
> http://lists.nongnu.org/mailman/listinfo/monit-general