[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Openexr-devel] Building custom OpenEXR
From: |
Larry Gritz |
Subject: |
[Openexr-devel] Building custom OpenEXR |
Date: |
Mon, 13 Aug 2012 12:49:11 -0700 |
In building the new 2.0.0 tagged code (on OSX 10.6, not sure if it makes any
difference), I'm finding that 'make install' for IlmBase is not copying several
files that OpenEXR later needs to compile. When I copy them by hand, to what
should have been the installation area, I can finally get a clean compile.
Here are the files I think are missed:
ImathExport.h
IexForward.h
IexMacros.h
IlmThreadExport.h
IlmThreadNamespace.h
IexExport.h
ImathNamespace.h
IexNamespace.h
Does this ring a bell for anybody?
--
Larry Gritz
address@hidden
- [Openexr-devel] Building custom OpenEXR,
Larry Gritz <=
- Re: [Openexr-devel] Building custom OpenEXR, Larry Gritz, 2012/08/13
- Re: [Openexr-devel] Building custom OpenEXR, Piotr Stanczyk, 2012/08/14
- Re: [Openexr-devel] Building custom OpenEXR, Larry Gritz, 2012/08/14
- Re: [Openexr-devel] Building custom OpenEXR, Piotr Stanczyk, 2012/08/14
- Re: [Openexr-devel] Building custom OpenEXR, Larry Gritz, 2012/08/14
- Re: [Openexr-devel] Building custom OpenEXR, Piotr Stanczyk, 2012/08/14
- Re: [Openexr-devel] Building custom OpenEXR, Larry Gritz, 2012/08/14
- Re: [Openexr-devel] Building custom OpenEXR, Piotr Stanczyk, 2012/08/14
- Message not available
- Re: [Openexr-devel] Building custom OpenEXR, Piotr Stanczyk, 2012/08/15