[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Partysip-dev] Re: problem with ringing tone
From: |
luke dobson |
Subject: |
[Partysip-dev] Re: problem with ringing tone |
Date: |
Mon, 22 Jul 2002 12:09:35 +0100 |
> > Hi All
> >
> > I am using partysip to connect two ciso ATAs together. I can make calls
> > and the voicepath is fine but I have a small problem. I have two
> > numbers 10 and 20
> >
> > 10 dials 20#
> > 20 starts to ring
> > there is no ringing tone at 10!
> >
> > My understanding of the message flow is this.
> > 10 sends an invite to the SIP which forwards to to 20
> > 20 sends a "180 ringing" signal back to 10. <-- I don't think this is
> > arriving.
>
> Right, partysip is not yet complete and when running in statefull mode,
> the provisionnal response are not forwarded. I have to rewrite some part
> of the code in this module and any quick hack to forward 180 will be
> a useless effort. Anyway, the next version will probably forward them.
Fair enough.
> > When I look in the logfile I don't see the reply.
>
> Can you confirm that the 180 is sent to partysip and not forwarded
> to the caller? This is the expected and wrong behavior...
I have just used a packet sniffer. Phone 1 called phone2. The 180 message
definately goes from phone2 to partysip but no 180 message emerges from
partysip to phone1.
> Aymeric
>
> > When I get the two phones to ring each other without SIP I get ringing
> > tone.
> >
> > Is this a partysip bug?
> >
> > Thanks in advance for any help
> > Cheers
> > Luke Dobson
At least I know my config is okay!
Thanks
Luke Dobson
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Partysip-dev] Re: problem with ringing tone,
luke dobson <=