[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Partysip-dev] Re: partysip config
From: |
luke dobson |
Subject: |
[Partysip-dev] Re: partysip config |
Date: |
Mon, 22 Jul 2002 12:16:59 +0100 |
>
> On Tue, 16 Jul 2002, luke dobson wrote:
>
> > Hi
> > I am using trying to use partysip with opensip to map phone numbers to
> > phones. I have terminals such as address@hidden and
> > address@hidden Dialling the entire IP, the phones can call each
> > other. However I would like to dial 10 and get address@hidden I
> > have played with the partysip.conf file and the user section looks like
> > this.
> >
> > user sip:address@hidden 10 aa
> > user sip:address@hidden 11 aa
>
> You can't do that. The url given for a user is made of his
> username @ domain.org where "domain.org is either 'serverip'
> or 'servername' from the partysip.conf.
Oh I see, this is basically for user authentication not any sort of routing.
> The real IP of user is received in the contact of REGISTER messages.
That makes sense.
> > authorisation is presently switched off
> >
> > When I call between the phones using the IP, I can see in the log that
> > the from: and to: fields are populated but when I dial the number alone
> > the to: field has a missing field.
> >
> > From: <sip:address@hidden;user=phone>;tag=2908867716
> > To: <sip:;user=phone>
>
> Is this message coming from your application? I don't see
> any reason why I should accept such a message.
Its coming from a Cisco ATA.
> > Further down the log contains the message
> >
> > | ERROR | <../../fsm/sipevent.c: 72> could not parse message
> > | ERROR | <udp.c: 220> udp module: Could not parse response!
> >
> > and partysip prints
> >
> > <msg_parser.c> error in msg_startline_init()
>
> the start line is the initial line of the request or response.
> You probably has the same value than in the "To" header above.
>
> > I assume I have done something silly in the config but what? Any help
> > much appreciated!
>
> Don't think it's related.
I have it working now. I think the ATAs were incorrectly configured for
SIP. Thanks for your help with the config file anyway.
> > TIA
> > Luke Dobson
Cheers
Luke Dobson
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Partysip-dev] Re: partysip config,
luke dobson <=