|
From: | Rama V |
Subject: | Re: [Discuss-gnuradio] Fwd: Re: Transmission error |
Date: | Wed, 16 Sep 2015 17:17:07 -0500 |
Do I need to use gnuradio - companion for transmission and reception of the data packets or the benchmark_tx.py commands from the terminal would be enough for that to happen. I am unable to sort out. Kindly help.
Regards,
Dave
---------- Forwarded message ----------
From: "Rama V" <address@hidden>
Date: Sep 15, 2015 7:47 PM
Subject: Re: Transmission error
To: <address@hidden>
Cc:Please kindly help with the above error
Thanks,
DaveOn Sep 14, 2015 5:02 PM, "Rama V" <address@hidden> wrote:DaveThanks,My PC is Dell Inspiron 15R 5537 and I think it's somewhat a new version. Do I need to mention any sample rate in the command of benchmark. And also when I set the sample rate to 250k in my benchmark command, my laptop freezes and I need to restart it again. Do I need to give a low value? Please help and excuse for my brevity.I tried to run this and I see an 'U' in the middle of transmission. Is this why I was not able to receive the packets because I getHey all,I have a small doubt regarding the reception of data packets. I am attaching a small figure of the command 'uhd_fft' where I mentioned the frequency and the sampling rate as 250k. The command I have given for this was
./benchmark_tx.py -m qpsk -M 2 --discontinuous -f 2.435G
ok = False pktno = 53034 n_rcvd = 1 n_right = 0
[Prev in Thread] | Current Thread | [Next in Thread] |