Hi,
As advised, the problem has been solved to a little extent
where I have got the below results by giving the commands
as
Sender : ./benchmark_tx.py -f 2.435G --tx-gain=25
Receiver: ./benchmark_rx.py -f 2.435G --rx-gain 50
ok: True pktno: 1971 n_rcvd: 1687 n_right:
358
ok: False pktno: 1972 n_rcvd: 1688 n_right:
358
ok: False pktno: 1973 n_rcvd: 1689 n_right:
358
ok: False pktno: 1974 n_rcvd: 1690 n_right:
358
ok: True pktno: 1975 n_rcvd: 1691 n_right:
359
ok: False pktno: 1976 n_rcvd: 1692 n_right:
359
ok: True pktno: 1977 n_rcvd: 1693 n_right:
360
ok: False pktno: 1978 n_rcvd: 1694 n_right:
360
ok: True pktno: 1979 n_rcvd: 1695 n_right:
361
ok: True pktno: 1980 n_rcvd: 1696 n_right:
362
ok: False pktno: 1981 n_rcvd: 1697 n_right:
362
ok: True pktno: 1982 n_rcvd: 1698 n_right:
363
ok: False pktno: 1983 n_rcvd: 1699 n_right:
363
ok: True pktno: 1984 n_rcvd: 1700 n_right:
364
ok: False pktno: 1985 n_rcvd: 1701 n_right:
364
ok: True pktno: 1986 n_rcvd: 1702 n_right:
365
ok: False pktno: 1987 n_rcvd: 1703 n_right:
365
ok: True pktno: 1988 n_rcvd: 1704 n_right:
366
This is because I have changed my folder to /digital/ofdm, I
have started to receive packets. But I guess this is only
50% efficient in receiving packets. Not all of them have
been receiving properly. kindly advise if I need to figure
out the combination settings till most of them receive
properly? Because even though I did not set any sample rate,
the transmitter sent the information. Please help. Please
excuse me if I am being naive in asking these.