On Sat, Oct 25, 2008 at 9:43 PM, Jonathan Kulp
<address@hidden> wrote:
Trevor, this is cool! I think in your first example, though, where you want to illustrate right-pointing flags on a lone note, you mean to say "set stemLeftBeamCount to zero"? Or do I misunderstand the example? Otherwise the first and second examples display the same thing.
Damn. Cut and paste error. Yes, you're totally right: the first example should talk about stemLeftBeamCount instead of stemRightBeamCount.
OK, let's try these:
%%%%%%% FLAT FLAGS & BEAM NIBS %%%%%
Flat
flags on lone notes and beam nibs at the ends of beamed figures are
both possible with a combination of stemLeftBeamCount,
stemRightBeamCount and paired [ ] beam indicators.
For right-pointing flat flags on lone notes, use paired [ ] beam indicators and set stemLeftBeamCount to zero.
\new RhythmicStaff {
\set stemLeftBeamCount = #0
c'16 [ ]
r8.
}
For left-pointing flat flags, set stemRightBeamCount instead.
\new RythmicStaff {
r8.
\set stemRightBeamCount = #0
c'16 [ ]
}
For
right-pointing nibs at the end of a run of beamed notes, set
stemRightBeamCount to a positive value. And for left-pointing nibs at
the start of a run of beamed notes, set stemLeftBeamCount instead.
\new RhythmicStaff {
c'16
c'16
\set stemRightBeamCount = #2
c'16
r16
r16
\set stemLeftBeamCount = #2
c'16
c'16
c'16
}
Sometimes it may make sense for a lone note surrounded by rests to
carry both a left- and right-pointing flat flag. Do this with paired [
] beam indicators alone.
\new RhythmicStaff {
c'16
c'16
\set stemRightBeamCount = #2
c'16
r16
c'16 [ ]
r16
\set stemLeftBeamCount = #2
c'16
c'16
}
%%%%%%%%%