[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Ltib] Re: Files/folders under ltib/rootfs/dev/ were not packed into
From: |
Quentin YANG |
Subject: |
Re: [Ltib] Re: Files/folders under ltib/rootfs/dev/ were not packed into rootfs.jffs2 |
Date: |
Wed, 24 Nov 2010 06:36:34 +1100 |
Thanks. Bruce.
Are you refering 'device_table.txt' under /ltib/bin/?
Where exactly should I copy it to?
My hardware board is 'gsncomm'. Shall I copy it like below?
' address@hidden ltib-qs]$ cp -p bin/device_table.txt
config/platform/gsncomm/ '
I'll try this first. Thanks.
Regards,
Quentin
On Wed, Nov 24, 2010 at 2:53 AM, Bruce <address@hidden> wrote:
> I have cvs version 1.62. I have the same dev list in rootfs as I do in my
> jffs2 after board boots. So it works right down to that version..
> I see ltib is using the device_list.txt file in your ltib/bin path which is
> probably a default file. You might want to make a copy into your platform
> config path. If you ever have a new platform, you probably don't want them
> using the same file.
>
> Thanks,
> Bruce
>
>
>
> On Mon, Nov 22, 2010 at 9:33 PM, Quentin YANG <address@hidden>
> wrote:
>>
>> More about cvs version difference.
>>
>> address@hidden lpc3250]$ diff ltib-GsnComms3240/ltib
>> ltib-Phytec3250/ltib
>> 118c118
>> < cvs_version => '$Revision: 1.68 $',
>> ---
>> > cvs_version => '$Revision: 1.71 $',
>>
>>
>> I am thinking to use old ./ltib cvs release, but apply
>> " kernel-arm-2.6.34-lpc32xx_update1.patch "
>> " kernel-arm-2.6.34-lpc32xx_update2.patch " two patches manually so
>> that 'ECC_HW_FLASH' can be enabled in new Linux Kernel Build.
>>
>>
>> Regards,
>> Quentin
>>
>> _______________________________________________
>> LTIB home page: http://ltib.org
>>
>> Ltib mailing list
>> address@hidden
>> http://lists.nongnu.org/mailman/listinfo/ltib
>
>