Hi all,
We have been implementing the prototype of Kemari for KVM, and we're sending
this message to share what we have now and TODO lists. Hopefully, we would like
to get early feedback to keep us in the right direction. Although advanced
approaches in the TODO lists are fascinating, we would like to run this project
step by step while absorbing comments from the community. The current code is
based on qemu-kvm.git 2b644fd0e737407133c88054ba498e772ce01f27.
For those who are new to Kemari for KVM, please take a look at the
following RFC which we posted last year.
http://www.mail-archive.com/address@hidden/msg25022.html
The transmission/transaction protocol, and most of the control logic is
implemented in QEMU. However, we needed a hack in KVM to prevent rip from
proceeding before synchronizing VMs. It may also need some plumbing in the
kernel side to guarantee replayability of certain events and instructions,
integrate the RAS capabilities of newer x86 hardware with the HA stack, as well
as for optimization purposes, for example.
Before going into details, we would like to show how Kemari looks. We prepared
a demonstration video at the following location. For those who are not
interested in the code, please take a look.
The demonstration scenario is,
1. Play with a guest VM that has virtio-blk and virtio-net.
# The guest image should be a NFS/SAN.
2. Start Kemari to synchronize the VM by running the following command in QEMU.
Just add "-k" option to usual migrate command.
migrate -d -k tcp:192.168.0.20:4444
3. Check the status by calling info migrate.
4. Go back to the VM to play chess animation.
5. Kill the the VM. (VNC client also disappears)
6. Press "c" to continue the VM on the other host.
7. Bring up the VNC client (Sorry, it pops outside of video capture.)
8. Confirm that the chess animation ends, browser works fine, then shutdown.
http://www.osrg.net/kemari/download/kemari-kvm-fc11.mov
The repository contains all patches we're sending with this message. For those
who want to try, pull the following repository. At running configure, please
put --enable-ft-mode. Also you need to apply a patch attached at the end of
this message to your KVM.
git://kemari.git.sourceforge.net/gitroot/kemari/kemari
In addition to usual migrate environment and command, add "-k" to run.
The patch set consists of following components.
- bit-based dirty bitmap. (I have posted v4 for upstream QEMU on April 2o)
- writev() support to QEMUFile and FdMigrationState.
- FT transaction sender/receiver
- event tap that triggers FT transaction.
- virtio-blk, virtio-net support for event tap.