Re: [Qemu-devel] [PATCH 4/7] savevm: Add VMSTATE_ helpers for target_phys_addr_t

[David Gibson]

On Wed, Oct 10, 2012 at 11:17:31AM +1100, David Gibson wrote:
> On Tue, Oct 09, 2012 at 05:24:29PM +0100, Peter Maydell wrote:
> > On 9 October 2012 13:53, David Gibson <address@hidden> wrote:
> > > Well, the place I've used this (in patches yet to be posted) is saving
> > > the state of the pseries machine itself.  Specifically, I use
> > > VMSTATE_TPA_EQUAL to sanity check that the restored machine has the
> > > same ram size as the saved machine.
> > 
> > This doesn't sound like the sort of check that should be in
> > a specific machine model -- you should be able to rely on
> > common qemu code to handle this. (If you can't then we need
> > a check in the common code...)
> 
> Hm, true.  Very well, I'll drop it, and the VMSTATE_TPA patch as
> well.

Actually, turns out I had another use of these helpers.  That was to
store the real page address from the ppcmeb_tlb_t structure.  That
structure is used to represent TLB entries on a number of different
embedded chips, which don't all have the same physical bus width.  So
target_phys_addr_t does seem like the correct type there.

Obviously I could change the type to a fixed uint64_t, but I'm not
sure if that's a better idea than bringing in the VMSTATE_TPA
helpers.  Advice?

-- 
David Gibson                    | I'll have my music baroque, and my code
david AT gibson.dropbear.id.au  | minimalist, thank you.  NOT _the_ _other_
                                | _way_ _around_!
http://www.ozlabs.org/~dgibson