[Simulavr-devel] [ 102189 ] display coprocesses / setting IO-Ports

[nobody]

Support Request #102189, was updated on Sun 06/08/2003 at 09:45
You can respond by visiting: 
http://savannah.nongnu.org/support/?func=detailsupport&support_id=102189&group_id=997

Category: None
Status: Open
Priority: 5
Summary: display coprocesses / setting IO-Ports

By: euphi
Date: Sun 06/08/2003 at 09:45
Logged In: YES 
user_id=19814
Browser: Mozilla/5.0 (X11; U; Linux i686; de-AT; rv:1.3) Gecko/20030425

Hi!

Yesterday I played around a while with simulavr, gdb
and ddd.
Simulation of test programs worked fine, but I haven't
found a possibility to read and set I/O ports.

After reading the docs (and exercising USTL), I think I
have to use a display process to show IO-Ports. But
I've seen no way to set them.

1. Is this right?
2. Are there any good display programs out there?



Thanks, Euphi

----------------------------------------------------------------------
You can respond by visiting: 
http://savannah.nongnu.org/support/?func=detailsupport&support_id=102189&group_id=997