Re: [Simulavr-devel] ATmega328 Emulation

[David Madden]

On 02/16/2011 08:14 PM, David Madden wrote:
> Hi, I'm a new user, hoping to use Simulavr to figure out how to run
> FreeRTOS on an ATmega328.

Uh oh, after more poking around, it's possible that it's a GDB 
communications (or pure GDB) issue.  Single-stepping goes to the 
expected instruction addresses, and the registers change as expected. 
It's just that x/i gives bad disassembly.  That makes it Really Hard to 
trace/debug, but it's better than nothing!

Any advice for fixing this?  My GDB is brand-new too: 7.2, compiled 
yesterday.

Thanks,
--
Mersenne Law LLC  ·  www.mersenne.com  ·  +1-503-679-1671
- Small Business, Startup and Intellectual Property Law -
1500 SW First Ave. · Suite 1170 · Portland, Oregon  97201