Re: Question about Installing on NT

[Cesar Perez]

When I double click on the icon I get the Swarm Symulation System pop up window
with two buttons that I can push: Finish or Cancel.  I push Finish. Then, I get
the flash of a small pop up window with an icon of a little open red box on the
left and an area which should fill up with color as the files are unpacked. It
looks similar to the one for unpacking the stuff from Cygnus.  Immediately I get
the unable to execute pop up with a button for OK.  When I press OK I get a pop
up that says:

A PackageForTheWeb ERROR
Unable to execute the specified command line.

I have 321 MB free in the C: drive.
I used the default path for Cygnus, but haven't had a chance to specify the
default path for Swarm.

For Paul:

I think I have permission as I was able to install the Cygnus stuff.

Marcus G. Daniels wrote:

> >>>>> "you" == Cesar Perez <address@hidden> writes:
>
> you> There is a "flash" of the usual window that shows the box opening
> you> and then the Unable to execute message.
>
> Please describe the the "usual window".  There are a variety of panels
> that come up during the installation.
>
> How much disk space do you have free?  Are you using the default installation
> paths that are shown (C:\Cygnus\B19 and C:\Swarm)?




                  ==================================
   Swarm-Support is for discussion of the technical details of the day
   to day usage of Swarm.  For list administration needs (esp.
   [un]subscribing), please send a message to <address@hidden>
   with "help" in the body of the message.
                  ==================================