[PULL 43/48] bcm2835_dma: Fix the ylen loop in TD mode

[Peter Maydell]

From: Rene Stange <address@hidden>

In TD (two dimensions) DMA mode ylen has to be increased by one after
reading it from the TXFR_LEN register, because a value of zero has to
result in one run through of the ylen loop. This has been tested on a
real Raspberry Pi 3 Model B+. In the previous implementation the ylen
loop was not passed at all for a value of zero.

Signed-off-by: Rene Stange <address@hidden>
Reviewed-by: Philippe Mathieu-Daudé <address@hidden>
Signed-off-by: Peter Maydell <address@hidden>
---
 hw/dma/bcm2835_dma.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/hw/dma/bcm2835_dma.c b/hw/dma/bcm2835_dma.c
index 1e458d7fba5..667d951a6f7 100644
--- a/hw/dma/bcm2835_dma.c
+++ b/hw/dma/bcm2835_dma.c
@@ -70,14 +70,14 @@ static void bcm2835_dma_update(BCM2835DMAState *s, unsigned 
c)
         ch->stride = ldl_le_phys(&s->dma_as, ch->conblk_ad + 16);
         ch->nextconbk = ldl_le_phys(&s->dma_as, ch->conblk_ad + 20);
 
+        ylen = 1;
         if (ch->ti & BCM2708_DMA_TDMODE) {
             /* 2D transfer mode */
-            ylen = (ch->txfr_len >> 16) & 0x3fff;
+            ylen += (ch->txfr_len >> 16) & 0x3fff;
             xlen = ch->txfr_len & 0xffff;
             dst_stride = ch->stride >> 16;
             src_stride = ch->stride & 0xffff;
         } else {
-            ylen = 1;
             xlen = ch->txfr_len;
             dst_stride = 0;
             src_stride = 0;
-- 
2.20.1