[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Ltib] libXt "failed dependencies"
From: |
Alan Carvalho de Assis |
Subject: |
Re: [Ltib] libXt "failed dependencies" |
Date: |
Tue, 14 Jul 2009 15:41:49 -0300 |
Hi Stuart,
On 7/14/09, Stuart Hughes <address@hidden> wrote:
>
> In your previous email, the install was failing as these dependencies
> were not met:
>
> error: failed dependencies:
> libc.so.6(GLIBC_2.0) is needed by libXt-1.0.4-5
> libc.so.6(GLIBC_2.1) is needed by libXt-1.0.4-5
>
>
> However, your base_libs are only providing 2.4/2.5/private. That looks
> a bit suspect, I normally get a load more (including 2.0/2.1).
>
> Which BSP are you working on and which toolchain does it select (maybe
> you can attached your platforms .config).
>
I am not using a FSL BSP, I am using the most updated LTIB from CVS.
> You could try running ./ltib -p base_libs -f and then re-check what it
> provides. The dependency in Xt looks reasonable to me.
>
Even after running "./ltib -p base_libs -f" it is only providing GLIBC
2.4 and 2.5.
To verify/confirm this issue I installed Ubuntu 9.04 into a virtual
machine and the same problem happened.
You can reproduce this problem this way:
1) Use a new and clean Linux machine (ie. Ubuntu 9.04)
2) Install needed LTIB dependency:
http://www.imxdev.org/wiki/index.php?title=ALL_Boards_ltib_config_ubuntu
3) Run ./ltib and select i.MX27ADS
4) Unselect Qtopia
5) Go ahead and wait few minutes until the error happen
Regards,
Alan