Hi Stuart,
On 7/14/09, Stuart Hughes <address@hidden> wrote:
In your previous email, the install was failing as these dependencies
were not met:
error: failed dependencies:
libc.so.6(GLIBC_2.0) is needed by libXt-1.0.4-5
libc.so.6(GLIBC_2.1) is needed by libXt-1.0.4-5
However, your base_libs are only providing 2.4/2.5/private. That looks
a bit suspect, I normally get a load more (including 2.0/2.1).
Which BSP are you working on and which toolchain does it select (maybe
you can attached your platforms .config).
I am not using a FSL BSP, I am using the most updated LTIB from CVS.
You could try running ./ltib -p base_libs -f and then re-check what it
provides. The dependency in Xt looks reasonable to me.
Even after running "./ltib -p base_libs -f" it is only providing GLIBC
2.4 and 2.5.
To verify/confirm this issue I installed Ubuntu 9.04 into a virtual
machine and the same problem happened.
You can reproduce this problem this way:
1) Use a new and clean Linux machine (ie. Ubuntu 9.04)
2) Install needed LTIB dependency:
http://www.imxdev.org/wiki/index.php?title=ALL_Boards_ltib_config_ubuntu
3) Run ./ltib and select i.MX27ADS
4) Unselect Qtopia
5) Go ahead and wait few minutes until the error happen
Regards,
Alan