[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [lwip-users] simrouter and simnode don't build
From: |
alex katebi |
Subject: |
Re: [lwip-users] simrouter and simnode don't build |
Date: |
Tue, 10 Aug 2004 08:09:17 -0700 (PDT) |
Hi Kieran,
Sure no problem I will try the cvs co tonight, and let you know the result.
Basically I am looking for a working application that I could use as a model to initialize the lwip for my application. I thought that lwip is developed using the unix port apllication in contrib. Since my application runs on linux I thought that the unix port application was appropriate for me to use. Are my assumptions wrong?
Thanks Again,
-Alex
"K.J. Mansley" <address@hidden> wrote:
On Tue, 2004-08-10 at 15:00, Jani Monoses wrote:
> > The CVS log suggests Jani removed them ages ago - back in March 2003.
> > Jani - can you throw any light on this? Perhaps simrouter is at fault
>
> I wish I could remember why I removed those :)
I thought it was a bit mean to try and get you to remember so far back
:)
> I'll take a look. I know I removed soem of the netif drivers because tapif
> seemed enough and those were not tested/used. I may have though unix is one of
> the sketch inetrfaces without actual use.
> So if the OP confirms that with your suggested change simrouter builds I'll
> add that back.
Not to worry - as Olivier Hachet reported the change worked, I've gone
ahead and committed it. It needed a couple of other mods to compile
(netif_add API must have changed at some point)
but hopefully is OK now.
Alex: could you check out the current CVS contrib and see if that works
for you?
Thanks
Kieran
_______________________________________________
lwip-users mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/lwip-users
Alex Katebi
Do you Yahoo!?
New and Improved Yahoo! Mail - 100MB free storage!