Re: [avr-chat] Crystals (was ATmega32 @ 16MHz : fuse bits ??)

[Vincent Trouilliez]

On Tue, 2005-11-15 at 00:24 +0000, Richard Urwin wrote:
> For what it's worth I have just built a ATmega16-16PI development board 
> on stripboard. I have a 12MHz crystal with the terminals 0.2 and 0.4 
> inches from their MCU pins and the capacitors 0.6 and 0.7 inches out 
> from the MCU. It runs fine.

Hi Rich,

That sounds very close to my setup bar 12MHz instead of 16. could you
tell me exactly the contents of your fuse bits, read from the chip ?

You can use avrdude:

$avrdude -t  (to enter 'terminal' mode)

the at the avrdude prompt, type:
> read hfuse
> read lfuse

Thanks in advance...


Regards,


--
Vince