Re: [Discuss-gnuradio] u2_flash_tool : Can not find the command

[Andy_Long]

Hi Johnathan, appreciate for your help. 


I have bought another brand (ADATA) 2GB SD card today and did the same thing
as before since I can not find any Kingston card available in shop.

1. I downloaded txrx.bin and u2_rev3.bin files from
http://gnuradio.org/releases/usrp2-bin/trunk/    

and u2_flash_tool from
http://gnuradio.org/redmine/repositories/changes/gnuradio/usrp2/firmware/u2_flash_tool
 

then put them into the same folder.

2. After that I use “chmond” to make the u2_flash_tool executable

3. Using sudo ./u2_flash_tool --dev=/dev/mmcblk0p1 -t s/w txrx.bin –w

   Take off the SD card from the reader and insert it back 

  Using sudo ./u2_flash_tool --dev=/dev/mmcblk0p1 -t s/w txrx.bin -v



4. Using sudo ./u2_flash_tool --dev=/dev/mmcblk0p1 -t s/w u2_rev3.bin –w

   Take off the SD card from the reader and insert it back 

  Using sudo ./u2_flash_tool --dev=/dev/mmcblk0p1 -t s/w u2_rev3.bin –v

5. There is no extra information after the verify command.

6. I put the SD card into the USRP2 and power it.

For sandisk SD card:  Only LED (F) is on
For ADATA SD card:  All LEDs are off

The same condition is described in here
http://old.nabble.com/Write-bin-to-SD-card-td21680697.html#a21720726

If every step is fine, maybe I guess I am a bit unluck and have to wait for
the replacement. Can I have another way to check if the firmware in SD card
is correct rather than the verify command? 

Andy

-- 
View this message in context: 
http://old.nabble.com/u2_flash_tool-%3A---Can-not-find-the-command-tp27760919p27783446.html
Sent from the GnuRadio mailing list archive at Nabble.com.